What makes these boots so great?
How are the boots sized?
Do the boots fit wide widths?
Are the collar and calf stiff?
Should people wear thick socks?
How does CR-foam compare or rate against other lofted insulations and waterproof membranes?
Do these boots allow your feet to breathe?
How do you care for and clean these products?
Q. What makes these boots so great?
A. It’s all in the design. All MUCK BOOTS™ are 100% waterproof keeping feet warm, dry and protected in harsh weather and messy working conditions. The secret – our exclusive, self-insulating, waterproof CR-foam shell construction. The CR-foam bootie material acts as a “neutral medium” between inside and outside temperatures. Naturally lightweight, and very comfortable, the material keeps the foot and lower leg warm and protected in cold and wet conditions.
Natural rubber overlays act as a protective skin for the upper bootie. The upper has a triple-reinforced toe area and quadruple-reinforced
heel area. The outsole is made of high abrasion natural rubber. The rubber in the boots will stay flexible for years.
-back to top
Q. How are the boots sized?
A. Standard U.S. sizes for men and women (unisex sizing). Boots and shoes are available in whole sizes only, but will stretch to fit half sizes. There is a 15mm toe allowance built into the sizing.
Q. Do the boots fit wide widths?
A. Yes. Our boots are made to standard widths, but the materials will stretch to fit widths up to a EEE. For narrow feet, we suggest wearing a thicker sock or putting in an additional sock liner to take up room.
Q. Are the collar and calf stiff?
A. No. The upper calf and topline areas are made of soft, flexible CR-foam and will stretch. With the flexible upper, the pant leg can be worn over or inside the boot. The collar material can be turned down to allow hands-free removal and vent humidity in warmer working conditions.
-back to top
Q. Should people wear thick socks?
A. It isn’t necessary unless activities are planned for extreme, cold conditions. The CR-foam bootie material is rated sub-zero during active use and will effectively withstand freezing temperatures for up to one hour. Medium-weight athletic socks should provide the best fit. The upper will stretch to accommodate thicker socks.
Q. How does CR-foam compare or rate against other lofted insulations and waterproof membranes?
A. Lofted insulations are typically used in work boots and hiking shoes to resist cold temperatures. They are typically laminated to the whole shoe lining or glued into the toe area of a shoe or boot. It is not a waterproof material.
The CR-foam used in MUCK BOOTS™ is both waterproof and self insulating. Our materials exceed the long-term effectiveness of waterproof membrane materials and provide greater insulating properties than all non-specialty temperature-control substrates.
-back to top
Q. Do these boots allow your feet to breathe?
A. One of the most important and revolutionary features of MUCK BOOTS™ footwear is the structured, Breathable Airmesh lining used in all our products. Airmesh is made up of thousands of tiny vertical fibers that allow air to circulate throughout the interior lining surfaces. Excess humidity and perspiration that might build up in the boot are quickly wicked away. This creates a comfortable environment for your feet that lasts for extended periods of use.
Q. How do you care for and clean these products?
A. The rubber shell and nylon upper are very durable and clean up easily with a spray of water or gentle scrubbing with soap and water. The rubber upper can be conditioned with wax polish, Armor All® or liquid detergent. It is not recommended to use conditioners on the outsole area. This may cause it to become slick in wet or icy conditions.
Q. Can the rubber be repaired if punctured?
A. Yes. The natural rubber can be repaired with sealant found in local hardware stores. We recommend Aquaseal® brand marine sealant. First, clean the punctured area thoroughly with mineral spirits. Then, apply the sealant over affected area and wipe to a thin film. The sealant should air dry for at least 24 hours.
-back to top
AQUASEAL® is a registered symbol of the McNett Corporation
ARMOR ALL® is a registered symbol of Armor All Products Company